Names And Functions Of Parts - Esoteric D-07X Manual Del Usuario

Names and functions of parts

A
A POWER button
Press to turn the power on and off.
When the power is on, the ring around the button lights blue.
B CLOCK indicator
Shows the clock sync or master clock status.
This indicator blinks when a signal is being input through the
clock sync connector.
When the signal is locked, the indicator stays lit without blinking.
C MENU button
Press to engage the setting mode (see page 12).
D Display
Displays the current input, sampling frequency, etc.
E Remote control sensor
Receives signals from the remote control unit.
Point the remote control unit at this sensor when using the
remote control.
You can use a remote control included with another Esoteric
product.
F PHONES jack
Connect headphones with a stereo 6.3 mm (1/4") plug here.
Audio is output through either the analog output (LINE OUT) jack
o
or the headphones (PHONES) jack.
Regardless of the input setting, audio will not be output from the
o
LINE OUT jacks if headphones are connected to the PHONES jack.
10
B
C
D E
G
F H
G INPUT button
Switches the digital input source.
Select the connector to which a digital device is connected.
The display flashes when no digital signal is being input.
The INPUT buttons on a remote control included with another
o
Esoteric product can also be used.
H VOLUME buttons
The volume level can be adjusted from –∞ (MUTE), –99.5 to 0.0 dB.
Use these buttons to adjust the volume when connected directly
to a power amplifier.
When a preamplifier is connected, set the volume to 0.0.
When in setting mode, these buttons are used to select options
within the menu item.
When headphones are connected to the PHONES jack, this
o
adjusts the headphones volume. When headphones are not con-
nected, this adjusts the analog audio output volume.
The VOLUME buttons (–/+) on a remote control included with
o
another Esoteric product can also be used.
You can use a remote control included with a P-05, K-05 or other
Esoteric products with this unit (see page 7).
When using a remote control included with another Esoteric product
to operate this unit, set "RC" (Remote control) to "Enable" (see page 18).