Publicidad
Idiomas disponibles
Idiomas disponibles
For solid-wall construction mount:
•
To secure the unit in concrete, pre-drill appropriately sized holes and use multi-set or wedge anchor
hardware at both mounting points.
•
To secure the unit in brick or stone, pre-drill appropriately sized holes and use sleeve anchors at
both mounting points.
The screw size and length recommended for mounting the EVSE is #10 and at least 2" (50 mm)
long to utilize the mounting tabs for a travel-friendly EVSE. Alternatively, a screw size of 1/4 - 20
and at least 2" (50 mm) in length can be used for permanent mounting of the EVSE.
It is important to note that if the mounting tabs are intended to be used for temporary mounting,
the diameter of the screw shaft must be larger than 0.25" (6.3 mm) and smaller than 0.42" (10.7
mm) to fit into the slot of the enclosure. Screw heads of 0.40" diameter are recommended.
14
Figure 3: Mounting screw slots of mobile EV charger
© 2024 Enphase Energy Inc. All rights reserved.
Mobile EV Charger EVSE User Manual
0.25" (6.3 mm)
Ǿ 0.42" (10.7 mm)
February 2024
140-00265-04
Publicidad
