GE WBVH5200 Manual Del Propietario E Instalación página 13

GEAppliances.com
Pour
spout
Cleaning the Pump Filter
Due to the nature of the front-load washer
it is sometimes possible for small articles
to pass to the pump. The washer has a
filter to capture lost items so theg are not
dumped to the drain. To retrieve lost items,
clean out the pump filter.
1. Using a coin or flat screwdriver
in the notch on the door, open
the access door.
2. Place a shallow pan or dish under
the pump access door and towels
on the floor in front of the washer to
protect the floor. It is normal to catch
about a cup of water when the filter
is removed.
& Pull down the pour spout.
4. Turn the pump filter counterclockwise
and remove the filter. Open slowlg to
allow the water to drain.
5. Clean the debris from the filter.
5. Replace the filter and turn clockwise.
Tighten securelg.
7. Flip up the pour spout.
8. Close the access door.
Cleaning the Door Gasket
Open the washer door. Using both hands,
press down the door gasket. Remove ang
foreign objects if found trapped inside
the gasket. Hake sure there is nothing
blocking the holes behind the gasket.
While holding down the door gasket,
inspect the interior gasket bg pulling it
down with gour fingers. Remove ang
foreign objects if found trapped inside
this gasket. Hake sure there is nothing
blocking the holes behind the gasket.
When gou are finished cleaning
the door gasket, remove gour
hands and the gasket will return
to the operating position.
13