• Fill up the tank with water before starting up the appliance. Be sure to unplug the appliance before pouring water into
the tank.
• Turn on the appliance only when it is in working position.
• Never leave the appliance unattended when it is connected to the power supply.
• When you have to leave for even a short period of time, turn off the appliance and always unplug the electric power cord.
• Store indoors in a cool, dry area.
sAve these instructiOns fOr future reference.
•
DescriptiOn Of the AppliAnce
A - Steam dispensing button
B - Handle
C - Swivel cord storage hook
D - Handle release button
E - "ON" indicator light
F - Tank release lever
G - Motor body
H - Water tank
I - Filter
J - Fixed cord storage hook
K - Steam head
L - Washable cloth
M - Power supply cable
N - Accessory for carpet cleaning
O - Washable cloth velcro couplings
P - Steam discharge nozzle
AsseMbling the AppliAnce
Proceed as follows after removing the appliance from the box:
Assemble the motor body to the steam head (Fig. 2). Tighten the screw supplied to lock the components (Fig. 3).
Warning!
Check the tightening of the screw from time to time.
Press the handle release button (D). Lift the handle until it is aligned with the motor body (Fig. 4-5).
instructiOns fOr use
Totally unwind the power cord. To make the operation easier, turn the hook (C) downwards.
Remove the tank. Lift the tank release lever upwards as shown by the arrow (Fig. 6). At the same time tilt and remove the
tank. Turn the tank upside-down. Remove the cap (Fig. 7). Fill the tank up to the MAX level directly beneath the tap with cool
tap water (Fig. 8). Screw the cap back on, but not with excessive force.
Warning!
NEVER fill the tank beyond the MAX level. If the tap water is particularly hard (higher than 20°f), use a mixture of
50% tap water and 50% demineralised water.
Put the tank back in, paying attention to match the tank valve with the pin in the appliance seat (Fig. 9). Press the tank all
the way down until it is completely inserted and check that it is correctly installed. Place the cloth under the steam head
(Fig. 10). Set the cloth above the velcro couplings.
Warning!
Make sure that the tank has been adequately filled to prevent dry operation.
Before using the appliance be sure that the objects and surfaces to treat are resistant or compatible with the high
steam temperature. It is recommended to consult the manufacturer's instructions and perform a test on a concealed
part or a sample particularly on treated terracotta tiles and wooden surfaces.
Warning!
If the appliance is left standing on the floor while it is in operation, you may notice a whitish ring. Do not be alarmed
because this can be removed with a decalcification agent or with some drops of vinegar.
Insert the plug into the socket, which must be earthed. The indicator lamp (E) will turn on, indicating that the appliance is on
11