INSTALLATION IN THE CAR
Seat installation
- Installation using ISOFIX and
Top Tether belt
- Child restrained by seat belt
Position the seat in one of
the 5 available positions (see:
Seat tilt adjustment).
- Installation using ISOFIX and
car belts - Installation using
car belts only
Position the seat in one of
the 5 available positions (see:
Seat tilt adjustment).
FORWARD-FACING (76 - 105 CM)
1.
Place the seat on the vehicle's seat in the position designated for installation.
2.
Push the ISOFIX lever (14, fig. B) and the ISOFIX arms extend automatically (fig.
1). Anchor the ISOFIX arms in the attachments located in the car seat. The arms
will interlock and you will hear a characteristic click (fig. 2).
3.
The green indicator on the ISOFIX button must be visible on both sides (fig. 3).
4.
Push the ISOFIX lever (14, fig. A) and press the seat against the backrest of the
car seat. Push the base with a left-right movement towards the backrest to make
sure it is pushed as tight as possible against the car seat.
5.
Adjust the seat angle to one of the 5 available positions (see: Seat tilt adjustment).
NOTE! Any change in the tilt of the backrest during use of the seat requires
readjustment of the length of the Top Tether belt.
6.
Unbuckle the Top Tether belt, then press the length adjuster (17, fig. B) to adjust
the belt length and move the buckle and hook to the end of the belt.
7.
Route the Top Tether belt under the headrest of the car seat (fig. 4).
8.
Attach the Top Tether belt to an anchor point in the car (fig. 5). The anchor points
may be in different locations depending on the vehicle (fig. 6).
9.
Tighten the Top Tether belt as tight as possible and make sure the indicator is
green (fig. 7). The seat is now correctly installed in the car.
EN
Seat
Seat position
orientation
Forward-
facing
Forward-
facing
‑ 14 ‑
Child's
measurements
From 76 to 105
cm
Child's weight:
maximum 18 kg
From 100 to
150 cm