Publicidad
Idiomas disponibles
Idiomas disponibles
TURN ON THE APPLIANCE AND SELECT PROGRAMME
Turn on the appliance
1
1. Slide out the upper and lower the basket, place the dishes inside and slide baskets back in
the dishwasher.
It is recommended to first load the lower basket and then the upper basket.
2. Pour detergent.
3. Insert the plug into the wall outlet. Information on the power supply can be found on the last
page in the chapter "Product fiche." Make sure that the water supply is turned on and set to
the maximum pressure.
4. Close the door, press the Power button.
5. Choose a program, the response light will turn on and then press the Start/Pause buttom.
Finally the dishwasher will start its cycle.
Change programme
2
You can change the programme only if it runs for a short time. Otherwise the detergent is alre-
ady dissolved in water and the water could be pumped out. In this case, refill the dispenser
with detergent and start the washing program from the beginning. To reset your dishwasher,
please follow the instructions below:
1. Press the Start/Pause to stop the machine, then press the program
3 seconds, the selected program will be cancel.
2. After the selected program be cancled, you can chose the desired program.
3. Press the Start/Pause button, the dishwasher will start.
Add dishes during the programme:
3
You can add extra dishes at any time before detergent is released. In this case, follow the
instructions below:
1. Press the Start/Pause button to pause the washing.
2. Wait 5 seconds then open the door.
3. Add the forgotten dishes.
4. Close the door.
5. Press the Start/Pause button, the dishwasher will continued to run after 10 seconds.
WARNING!
Be careful when opening the door during the dishwashing programme as hot steam
can be released and cause scalding.
button for more than
101
Publicidad
