Publicidad
Idiomas disponibles
Idiomas disponibles
CYLINDER
1. Remove
spark plug.
2.
Pour one ounce
(29 ml) of oil through
spark plug hole into cylinder.
3, Pull starter
handle slowly a few times
to distribute
oil.
4.
Replace
with new spark plug.
OTHER
• Do not store gasoline
from one season
to another.
• Replace
your gasoline
can if your can
starts to rust.
Rust and/or
dirt in your
gasoline
will cause problems.
• If possible,
store your unit indoors and
cover it to protect it from dust and dirt.
• Cover your unit with a suitable protective
cover that does not retain moisture.
Do
not use plastic.
Plastic cannot breathe,
which allows condensation
to form and
will cause your unit to rust.
IMPORTANT:
Never cover mower while
engine and exhaust
areas are still warm.
ACAUTION:
Never store the lawn mower
with gasoline
in the tank inside a building
where fumes may reach an open flame
or spark.
Allow the engine to cool before
storing in any enclosure.
TROUBLESHOOTING
- See appropriate
section
in manual
unless directed
to a Sears
Service
Center.
PROBLEM
CAUSE
Does not start
1. Dirty air filter.
2.
Out of fuel.
3.
Stale fuel.
4. Water in fuel.
5.
Spark plug wire is
disconnected.
6.
Bad spark plug.
7.
Loose
blade or broken
blade adapter,
8. Control
bar in released
position.
9. Control
bar defective.
10. Fuel valve lever (if so
equipped)
in OFF position.
11. Weak battery
(if equipped).
12. Disconnected
battery
CORRECTION
1. Clean/replace
air filter.
2.
Fill fuel tank.
3.
Drain tank and refill with
fresh, clean fuel,
4.
Drain fuel tank and
carburetor
and refill tank
with fresh gasoline.
5.
Connect
wire to plug.
6.
Replace spark plug,
7.
Tighten
blade bolt or
replace blade adapter.
8.
Depress control bar to
handle.
9.
Replace control bar.
10.Turn fuel valve lever
to the ON position,
11 .Charge
battery.
12. Connect
battery to engine.
IS
Publicidad
