Publicidad
Idiomas disponibles
Idiomas disponibles
Operation:
Plug the power cord into a 220-240 Volt 15 Amp outlet. Make sure the outlet is in good condition
and that the plug is not loose. NEVER exceed the maximum amperage for the circuit.DO NOT
plug other appliances into the same circuit.
Cleaning:
•
Turn heater OFF and unplug from electrical outlet before any cleaning or maintenance
is performed. Wait at least 10 minutes to allow all components to cool properly.
•
Use a vacuum or duster to keep heater and vent area clean from dust and dirt.
•
The exterior of the fireplace should be cleaned with a damp cloth or duster.
•
Do not use abrasive cleaners or liquid sprays.
WARNINGS AND CAUTIONS:
•
To avoid electrical shock does not open the back panel of the insert unless the Power
has been turned off. And the insert has been unplugged.
•
Any electrical repairs.to this electric fireplace. Should only be Performed by a qualified
technician.
Any electrical wiring repairs should only be performed by a qualified Technician. And
•
also, must
•
comply with local buildings codes.
•
Discontinue use of this electric fireplace if any of the follow has Occurred: Water
damage. If insert.
•
has been or dented. If power cord has Become broken. If power cord becomes hot to
touch, if unit smokes or smells like smoke.
Note: When the heat functions is used for the first time. A slight odor may be Present. This is
normal and should be occur again unless heater is not used for extended periods of time
and dust is allowed to accumulate on heater Element.
Hergestellt für Dilaw Warehouse GmbH // Fuggerstraße 15a // 48165 Münster // Germany
25
www.eshopping.de
Publicidad
