Publicidad
Idiomas disponibles
Idiomas disponibles
If you place a mobile device on the wireless charging surface for an
extended period, the wireless charger may overheat and stop
charging.
Do not cover or block the heat release vent at the back of the clock.
When the mobile device is fully charged, remove it from the wireless
charging surface.
Do not place foreign materials, such as metal objects, magnets,
magnetic stripe cards, paper clips etc. between the mobile device and
the wireless charging surface. The mobile device may not charge
properly or may be damaged due to overheating.
Wireless charging may not work properly if you attach a thick case to
your mobile device. If your case is thick, remove it before placing your
mobile device on the wireless charging surface.
If you connect a charger to the mobile device during wireless charging,
the wireless charging feature will be unavailable.
TO CHARGE MOBILE DEVICES WITH THE USB PORT
Connect the charging cable of your mobile phone (not included) to the A-
type USB port at the back of the unit, then connect the other end to your
mobile phone. The clock will charge the mobile phone automatically.
Notes:
Make sure to use the original cable of your mobile phone for charging
Make sure the original adaptor (DC 5V / 2.0A) enclosed with your clock
is being used to power your clock. Using other adaptors may not
charge your phone.
iPad, tablet and notepad charging is not applicable.
Charging one mobile device by the USB port and another mobile
device by the wireless charger at the same time will reduce the
charging efficiency and extend the charging time.
TO SET TIME AND SNOOZE DURATION (default time is at 0:00)
Press and hold the
hour digit "0" flashes. Press the
Press the
or the
button, once during time display mode and, the
button once again, the minute digits "00" flash. Press the
button to set the minutes.
or the
button to set the hours.
EN6
Publicidad
