Publicidad
Idiomas disponibles
Idiomas disponibles
7
WARNING:
product is switched off and the battery is disconnected
before adjusting, adding accessories, or checking a
function on the product.
INSTALLING FRONT SWITCH AND
HANDLE (FIG 2)
S1
2a
FIG 2
1.
Install the front switch (2) by engaging the square blocks
on the open ends of front switch with the square slots
(2a) on the housing, following the angle shown in FIG 2.
2.
Install the front handle (4) by positioning it over the front
switch, ensuring alignment with the screw holes (S2) on
both sides of the housing.
3.
Tighten two screws (S1) on each side to secure the front
handle in place.
PRODUCT OVERVIEW
9
6
FIG 1
ASSEMBLY AND ADJUSTMENTS
Always be sure that the
4
2
S2
2
4
5
8
INSTALLING THE SAFETY GUARD
(FIG 3)
5
S3
1.
Slide the safety guard (5) onto the housing as shown in
FIG 3. Ensure alignment of the screw holes (S3) on the
guard with the screw holes (S4) on the housing.
2.
Tighten a screw (S5) on each side to secure the safety
guard in place.
INSTALLING AND REMOVING THE
BATTERY PACK (FIG 4)
FIG 4
ENGLISH
1
3
1. Rear Trigger Switch
2. Front Switch
3. Battery Pack
4. Front Handle
5. Safety Guard
6. Blades
7. Blade Tip Protection
8. Blade Cover
9. Charger
S5
S4
FIG 3
3
3a
Publicidad
