2.4.
Safe use of the device
a)
Do not overload the device. Use tools that are suitable for the application. A
correctly selected unit will do a better and safer job for which it was designed.
b)
Do not use the device if the "ON / OFF" switch does not work properly (does
not turn the device on and off). Units that cannot be controlled by the switch
are unsafe, cannot operate, and must be repaired.
c)
Disconnect the device from the power supply before adjusting, cleaning, or
servicing. This precaution reduces the risk of accidental start-up.
d)
Keep unused product out of the reach of children and anyone unfamiliar with
the device or this manual. Products are dangerous when used by
inexperienced users.
e)
Keep the product in good working order. Check before each use for general
damage or damage to moving parts (cracks in parts and components or any
other condition that may affect the safe operation of the device). If damaged,
return the device for repair before use.
f)
Keep the product out of the reach of children.
g)
Repairs and maintenance should be carried out by qualified personnel using
only original spare parts. This will ensure the safety of use.
h)
To ensure the designed operational integrity of the device, do not remove
factory-installed covers or loosen screws.
i)
When transporting or moving the device from storage to the place of use,
observe the health and safety rules for manual handling applicable in the
country where the device is used.
j)
Avoid situations where the unit stops working because it is handling a heavy
load. This can cause overheating of the drive elements and consequent
damage to the equipment.
k)
Do not touch any moving parts or accessories unless the device is unplugged.
l)
Do not leave the device switched on unattended.
m) Clean the device regularly to prevent permanent dirt build-up.
n)
The product is not a toy. Cleaning and maintenance must not be performed by
children without adult supervision.
o)
Do not tamper with the device to alter its performance or design.
p)
Keep the unit away from sources of fire and heat.
q)
Do not exceed the maximum load of the product.
r)
Keep hands and fingers away from moving parts when unfolding, folding, or
adjusting the product.
s)
Always use the brake when parking the trolley to make sure it does not roll
away.
EN