VONROC RT501AC Traducción Del Manual Original página 13

TECHNICAL SPECIFICATIONS
Model no.
Voltage
Frequency
Current
Table dimensions without extensions
Table dimensions with extensions
Table height
Max. router bit diameter Dmax:
Max. installed router weight
Max. installed router power
Max. router baseplate diameter
Max. workpiece dimensions:
Width
Length
Height
Weight
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2 - 7.
1. Fence
2. Table Extension
3. Mitre Guide
4. Feather Board
5. Switch Box Outlet
6. On/Off Switch
7. Guard
8. Dust Port
9. Leg
10. Table
3. ASSEMBLY
The router table must be fully assembled
before use.
Attaching the legs and table extensions (Fig. C, D)
Use 16, 18mm Phillips head assembly fasteners as
shown on figure B1.
1. With the table and one table extension upside
down on a flat surface, align the table exten-
sions as shown on figure C. Once aligned, slide
the table and table extension together.
WWW.VONROC.COM
2. Place table leg as shown on figure D. Loosely
RT501AC
230–240 V ~
50 Hz
3. Repeat step 3 above for opposite table leg.
8A max.
4. Once both table legs are loosely fitted, ensure
460x335 mm
870x335 mm
280 mm
5. Repeat steps for the other table extension and
Ø22 mm
3.5 kg
1800 W
155 mm
Insert router mounting bolts (Fig. E, F)
Use 4, 50mm Coach bolts, router clamps and as-
sembly fasteners as shown on figure B2.
100 mm
1. Insert four 50mm coach bolts into the holes as
2000 mm
55 mm
2. From the underside, loosely fit bracket, washer
7.0 kg
Attaching Fence (Fig. G, H)
Use 2, 40mm bolts with star knob, washers and
nuts as shown on figure B3.
1. Place the fence on the table.
2. Place a washer on each bolt, then insert the
3. Place a square nut on each bolt on the under-
4. Tighten the bolts using the star knobs.
Attaching Fence Feather Boards (Fig. I, J)
Use 4, 40mm Coach bolts, washer and wing nut
assembly fasteners as shown on figure B4.
1. Fit the fence feather boards to the front of the
2. Pay attention to the feed direction as shown on
fix in position using four screws and flange lock
nuts, do not fully tighten yet.
NOTE: The table leg fits inside the table profile,
with fixing screws inserted from the outside.
the table and table extension are lying perfectly
flat, gently tighten all screws, working from the
centre to the outside.
table legs. Once all four legs are securely tight-
ened, turn assembly over and check the router
table does not rock.
shown on figure E from the top of the table.
and flange nut as shown on figure F. Do this for
all four bolts.
bolts through the cutout slots in the fence and
table as shown in figure H.
side of the table as shown in figure G. Align the
square nuts with cutout slots.
Incorrectly orientated feather boards may
cause workpiece kickback and cause
serious injuries.
fence as shown on figure I.
figure J.
EN
13