9.
Keep children and unauthorised persons away from the machine when in use. DO NOT use as a toy.
10. DO NOT use if it has been damaged, left outdoors or dropped in water.
DO NOT use where hazardous dust is present.
11.
DO NOT use in an explosive atmosphere.
12.
13.
DO NOT pick up or use near flammable or combustible fluids, hazardous dusts or vapours.
14. CAUTION - If it is suspected that there is hazardous dust or flammable/corrosive material, stop cleaning the area immediately
and consult your superior.
DO NOT use to clean up any burning or lighted materials such as cigarettes, matches, ashes or other combustible objects.
15.
16.
Only use the machine on firm level surfaces. DO NOT use on a gradient or slope of more than 2%.
DO NOT use on rough, uneven surfaces e.g., industrial, or coarse concrete surfaces.
17.
18. DO NOT use outdoors e.g., on patios, decks or rough surfaces.
19.
CAUTION - This machine is for dry indoor use only and should not be used or stored outdoors in wet conditions.
20. Take care when using a machine near the top of stairs to avoid overbalancing.
21.
DO NOT cover the machine when in use.
22. DO NOT run the machine dry, as this could damage the floor surface or the machine itself.
23. DO NOT leave machine running unattended.
24. Keep hair, loose clothing, hands, feet and all other parts of the body away from openings and moving parts.
25. DO NOT put any object into openings. DO NOT use with any opening blocked; keep free of dust, debris and anything that
may reduce airflow.
26. DO NOT use volatile or combustible solvents (e.g., diesel/petrol/IPA/trichloromethane) nor any corrosive, toxic or highly
irritant substances to wash floors, even if diluted. In the event of accidental contact with any such substances (e.g., due to
spills) follow the decontamination procedures in force at the user site. If in any doubt about the condition of the machine,
contact Truvox or the dealer/agent who supplied the machine.
27. DO NOT operate the machine if it malfunctions or is damaged in any way. Contact an authorised service agent for repair or
adjustments.
28. DO NOT leave the machine connected to the electricity supply when not in use, always remove the plug from the socket-
outlet.
29. WARNING DO NOT fill the machine with water hotter than 40ºC.
CAUTION - Risk of electric shock
30. DO NOT operate the machine with a damaged power cord or plug, or after the machine malfunctions or is damaged in any
way. Contact an authorised Service Agent for repair or adjustment.
31.
The machine must be kept clean and in good condition with regular inspections of the power cord and plug for signs of any
damage. If any parts are damaged, they shall only be replaced by an approved part by the manufacturer, its service agent or
a similar qualified person in order to avoid a hazard.
32. Only replace the power cord with the type specified in the instruction manual.
33. When unplugging, pull the plug, not the power cord.
34. WARNING: Keep the power cord clear of moving parts.
35. DO NOT kink or twist the power cord and keep cord away from heated surfaces.
36. The power cord plus any extension leads should not exceed 30 metres in total. The cross section of an extension cable wiring
must be at least 2.5mm².
37. DO NOT pull or carry by the power cord. DO NOT use cord as a handle, close door on cord or pull cord around sharp edges or
corners.
38. Switch off the machine before removing the plug.
39. DO NOT operate switches or touch the mains plug with wet hands as this may cause electric shock.
40. This machine should always be connected to a fully earthed power supply of the right voltage and frequency.
41. The machine shall be disconnected from its power source when not in use and before commencing cleaning of the machine
or maintenance and when replacing parts or accessories, by removing the plug from the socket-outlet.
USE ON ESCALATORS
42. Ensure the machine is positioned at the bottom of the escalator with the escalator moving towards the operator.
FOR UK MARKET
•
Plug: Moulded plug, UK standard, 3 pin, 250V, 13A rated with BS approval and in-built fuse.
Cable: 3 x 1.0 SQ mm PVC insulated Cable, type H05VV-F with VDE/KEMA-KEUR approval.
•
•
Connector: Moulded connector, 250V,10A rated, IEC C13 Connector with BS approval.
CLEANING AGENTS
1.
When using cleaning and care agents, the manufacturer's danger warnings must be followed and protective goggles and
clothing must be worn.
2.
Only use low-foaming, non-combustible cleaning agents which do not contain generally health-hazardous substances.
3.
Please ensure that after each use any chemical residue is rinsed out with clean water.
BRUSH IDENTIFICATION
4
(04-23)