Hkoenig kub14 Manual De Instrucciones página 14

PROBLEM
The compressor works
abnormally with
buzzing noise
Water shortage
indicator light is on
Indicator lights
control panel are not on
The ice made is too
large and with pieces
sticking together.
The ice making process
was correct, but no ice
came out?
All indicator lights flash
at the same time.
The machine has been
working, but the water
has been warming
When the ice is full, the
machine does
display the ice full icon
POSSIBLE CAUSE
The voltage is lower than
a
recommended
There is no water
1.
The pump is full of air
2.
on
Blown fuse/ No power
1. Ice of previous cycles
left in the water tray
1. The compressor has
no refrigerant
2. Compressor damaged
3. Fan motor damaged
1. The water box is
blocked by ice.
2. The motor is stuck, or
the motor falls off, or the
motor is damaged
3. Micro switch damaged
Solenoid broke down
1. Ice full sensor damaged
not
2. Solar light interference
SUGGESTED
SOLUTIONS
Stop the ice maker and do not
restart until the voltage is normal.
1. Add some water until it
reaches MAX position
2. Press START/PAUSE button
to restart the machine
Replace fuse / Turn power on
Take out the ice under the
standby state
Call the service hotline
1. Take out the ice under the ice
shovel, plug in power again, and
press the POWER button. After 3
minutes, the machine will restart
automatically.
2. Call the service hotline
Replace the solenoid valve
1. Replace the ice full sensor
2. Making ice indoor
3. Call the service hotline