Publicidad
Idiomas disponibles
Idiomas disponibles
EN
After setting the appliance to another type of gas, it is necessary to change the gas indicated on the
technical plate located in a visible place on the back of the appliance.
Before using the device for the first time, you must remove the protective film from all surfaces and wash the
device with water and detergent. Then splash it with clean water. Use the device under supervision. Never
use the appliance without oil or if the oil level is below the minimum level - danger of fire. If the oil is dirty or
you use the oil for a longer time, it may cause boiling.
- Ignition of the main burner and temperature adjustment: images A,B
Turn the adjustment knob (2) to the "main burner ignition" position, then press and hold it. Press the igniter
piezo button (1) several times until the main burner burns. The flame is visible through the slot in the front
panel. After lighting the burner, keep the button (2) pressed for several seconds until the hot melt becomes
hot. Then release the button. If the flame goes out, repeat the operation.
- How to turn off the entire device: image A,B
Turn the knob (2) to position "0".
Comments and recommendations
Always check the oil level, never use the device without oil. Use the device only under supervision.
Publicidad
