N8WERK KESS4103-GS Manual Del Usuario página 12

Danger of scalding from heat, hot steam
or condensation!
■ Avoid coming into contact with the
rising steam. Do not open the lid of
the device during operation.
■ Do not move the device during
operation.
■ Make sure that the connecting cable
does not present a trip hazard. The
connecting cable may not hang down
from the surface on which the device
is placed in order to prevent the device
from being pulled down.
■ Make sure that the connecting cable is
kept out of the reach of small children
and animals. There is a danger of
strangulation!
NOTICE – RISK OF DAMAGE TO
MATERIAL AND PROPERTY
■ Switch off the device and pull the
mains plug out of the plug socket if an
error occurs during operation or before
a thunderstorm. When you pull the
mains plug out of the plug socket, al-
ways pull on the mains plug and never
the mains cable!
■ Never pull or carry the base station by
the connecting cable.
■ Protect the device from other heat
sources, naked fl ames, sub-zero
temperatures, persistent moisture, wet
conditions and impacts.
■ Never place heavy objects on the base
station or the connecting cable.
■ Use only original accessories from the
manufacturer in order to guarantee
that there is no interference that may
prevent the device from working and to
avoid possible damage.
12
PUTTING INTO
OPERATION
Please Note!
■ Do not place the device below kitchen
wall units or similar cupboards. The
rising steam could cause damage to
them!
■ Lay the connecting cable in such a way
that it does not become squashed or
bent and does not come into contact
with hot surfaces.
1. Place the base station (6) on the
kitchen unit or another suitable work
surface. Ensure there is suffi cient clear
space on all sides (at least 20 cm to
the sides and 50 cm above).
2. Connect to a plug socket that is proper-
ly installed. The mains voltage must be
the same as that stated in the techni-
cal data for the base station.
The plug socket must be readily ac-
cessible so that the connection to the
mains can quickly be isolated.
BEFORE INITIAL USE
Clean the kettle thoroughly before you fi rst
use it to remove any possible production
residues. To do this, fi ll it with water up to
the MAX marking, allow it to boil and then
pour away the water. Perform this process
at least twice.