Descargar Imprimir esta página

DeWalt DW955 Manual De Instrucciones página 7

Taladro/destornillador inalambrico angulo recto
Ocultar thumbs Ver también para DW955:

Publicidad

Idiomas disponibles

Idiomas disponibles

battery condition.
The charger will t hen g oontocharge the battery to
the highest capacity possible.
ALLCHARGERS
Leaving the battery
pack in the charger: When the red light remains
ON, the charger has switched to its "equalize
charge" mode which
lasts approximately
4 hours, after which the charger will switch to
"maintenance
charge"
mode. The battery pack can be removed
at
any time during these charge cycles, but will only be fully charged if the
red light is continuously ON. The charger and battery pack can be left
connected with the red light glowing indefinitely. The charger will keep
the battery pack fresh and fully charged. A battery pack will slowly
lose its charge when kept out of the charger. If the battery pack has not
been kept on maintenance charge, it may need to be recharged before
use. A battery pack may also slowly lose its charge if left in a charger
that is not plugged into an appropriate AC source.
Important
Charging
Notes
1. Longest life and best performance
can be obtained if the battery
pack is charged when the air temperature is between 65°F and 75°F
FIG. 3
FIG. 2
!
!
FTON
c
FIG. 4
/
/
(I8 °- 24°C). DO NOT charge the battery pack in an air temperature
below +40°F(+4.5°C), or above +I05°F (+40.5°C). This is important
and will prevent serious damage to the battery pack.
2. The charger and battery pack may become warm to touch while
charging.
This is a normal
condition,
and does not indicate
a
problem.
3. If the battery pack does not charge properly -- (1) Check current at
receptacle by plugging in a lamp or other appliance, (2) Check to see
if receptacle
is connected
to a light switch which turns power off
when you turn out the lights. (3) Move charger and battery pack to a
location where the surrounding
air temperature
is approximately
65°F - 75°F (18 °- 24°C). (4) If charging problems persist, take or
send the tool, battery pack and charger to your local service center.
4. The battery pack should be recharged
when it fails to produce
sufficient power on jobs which were easily done previously. DO NOT
CONTINUE
to use under these conditions.
Follow the charging
procedure. You may also charge a partially used pack whenever you
desire with no adverse affect on the battery pack.
z_Do not immerse charger in water or any other liquid.
WARNING:
Don't allow any liquid to get inside charger. Electric

Publicidad

loading

Este manual también es adecuado para:

Dw965Dw966