Xiaomi S10+ Manual De Usuario página 12

Care & Maintenance
Sensors and Charging Contacts
Use a soft cloth to clean all sensors and charging contacts in the robot vacuum:
The cliff sensors and the charging contacts at the bottom of the robot vacuum.
•
The LDS laser sensor on the top of the robot vacuum.
•
The bumper and the line laser sensors on the front of the robot vacuum.
•
11
* It is recommended to clean every month.
LDS Laser Sensor
Bumper
Line Laser Sensor
Cliff Sensor
Charging Contacts
Brush and Side Brush
* It is recommended to clean every two weeks.
1. Flip the robot vacuum over and pinch the clips to remove the brush cover.
2. Lift the brush out of the robot vacuum, then clean the brush bearings.
3. Use the included cleaning tool to cut any tangled hairs on the brush, and
remove the hairs and other debris from the brush.
4. Remove the side brush upwards to clean it.
5. Reinstall the brush, the side brush and the brush cover, and ensure they are
securely in place.
Notes:
· It is recommended to replace the brush every 6–12 months for optimal cleaning performance.
· It is recommended to replace the side brush every 3–6 months for optimal cleaning performance.
Brush Cover
Clip
Brush
Brush Bearings
CAUTION:
If too much hair is tangled in the brush, or if the hair is tightly tangled, do not forcibly
pull on it to avoid damaging the brush.