sunjoe TJ604E Manual Del Operador página 10

m
WARNING!
Check the voltage to ensure it complies with
the information on the rating label.
Wheel Adjustment
m
WARNING!
Always switch the product off and disconnect
it from the power supply before making any adjustments.
The wheels can be adjusted to 3 different positions to control
the cultivating depth.
1. Pull the wheel and move it to the desired position; let go
of the wheel and make sure it locks into position (Fig. 6).
Be sure to set both wheels to the same height.
Fig. 6
adjustment
Transport Work position
position
m
WARNING!
Always ensure the wheels are securely
locked. Do not attempt to use the product with the wheels in
unlocked positions.
Powering ON + OFF
m
WARNING!
Rotating tines may cause serious injury.
The tines will continue to turn for a few seconds after the tool
has been switched OFF. Do not touch the rotating tines. Contact
with hot components (i.e. motor housing, gear box, etc.) on the
machine may cause burns. Allow the machine to cool before
handling.
1. To turn the tool ON, push and hold the safety lock button
with your thumb and then squeeze the trigger switch with
your fingers. Once the tool is running, release the safety
lock button (Fig. 7).
Fig. 7
2. To switch OFF, release the trigger switch (Fig. 7).
Wheel
Wheel
Work position
(low) (high)
Safety lock button
Trigger switch
Operating Tips
• Before each use, check the product, its power cord and
plug, and any other accessories for damage. Do not use the
product if it is damaged or shows wear.
• Double check that the accessories and attachments are
properly fitted.
• Always hold the product by its handles. Keep the handles dry
to ensure a secure grip.
• Ensure that the air vents are always unobstructed and clear.
Clean them if necessary with a soft brush. Blocked air vents
may lead to overheating and damage the product.
• Switch the product off immediately if you are disturbed while
working by other people entering the working area. Always
let the product come to a complete stop before averting your
attention.
• Do not overwork yourself. Take regular breaks to ensure you
can concentrate on the task at hand and have full control
over the product.
m
WARNING!
In some countries, regulations define
restrictions for use of such products, including the times and
days when operation is permissible. Ask your community for
detailed information and observe these regulations in order
to preserve a peaceful neighborhood and avoid committing
administrative offences.
Tilling
• Make sure that the work area is clear of stones, sticks, wire,
or other objects that could damage the product or its engine.
• Do not till very wet soil because wet soil tends to stick to the
working tool, preventing proper tine rotation; it could also
cause you to slip and fall.
• Always maintain a firm grip on the product. For better
guidance, apply light pressure to the handles.
m
WARNING!
Do not place hands, feet, or any other part of
the body or clothing near the rotating tines or any other moving
part. The tines begin to rotate forward once the trigger switch is
depressed. The tines continue to rotate until the trigger switch
is released. Failure to avoid contact with the rotating tines could
cause serious personal injury.
• Do not try to till too deeply or force the product into soil that
is extremely hard or resistant.
• Walk the product through the soil at a normal pace and in as
straight a line as possible.
• Till in slightly overlapping rows. To till most effectively, follow
the pattern indicated in Fig. 8. Start by moving the tiller +
cultivator up and down in vertical lines, then work horizontally
from left to right. This will keep the rows even and ensure that
all the ground is tilled without missing any spots.
10