Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
1. Put the required batteries rechargeable in the item (3x AA, not
included).
2. Connect the tubes to the inlet and outlet of the controller,
making sure that the inlet end is connected to the filter and the
outlet end is connected to the 3-way anti-siphon connector.
3. Set the desired programme. Frequency can be used to set a
regular time between waterings.
Note: The Frequency must be set to a value higher than the Run Time,
otherwise the setting will be cancelled.
4. Set delay function: Here is an example if you want to set the
Frequency to 1 day, Run Time to 5 minutes and the watering
start time to 18:00 but have a current clock time of 9:00. Press the
Delay button for more than 2 sec. until the LED is ON, then release
the Delay button so that from now on each press of the Delay
button will add a 1-hour delay. In this case you need to press the
Delay button 9 times to create a 9-hour delay. Delay time can be
set to between 0 and 23 hours. If the Frequency is changed to
another value in any situation, the next watering start time is
also changed. Changing the Run Time will not change the next
watering start time.
5. I n normal working situations, the LED will blink every 4 seconds,
which means that all settings are working properly. When the LED
blinks very quickly, it means the battery is low and you should
replace the batteries with new ones. When the batteries are low,
the controller will shut down and the watering programme will
stop working.
0_A4_Corretto.indd 30
0_A4_Corretto.indd 30
29
FR
ES
PT
IT
EL
PL
UA
RO
EN
15/01/24 12:3
15/01/24 12:3
Publicidad
