Publicidad
When on, the field strength data
‚
logger will record all the values
measured every second. These
values are accessible via the PC
application available from
www.fieldsense.com.
Once the fieldSENSE 2.0 is on,
‚
the fall detection & alarm system
is armed and in the event of a
EXPOSURE LOGGING
The fieldSENSE 2.0 records the
cumulative exposure from all RF
sources within its operating frequency
and exposure dynamic range. It
records it as the Maximum, E and H
percentages with the associated date
and time thereof.
It is important to synchronize your
‚
device time to your local time by
plugging it into a PC running the
FieldSENSE app available from
www.fieldsense.com.
The reported and recorded values
‚
are a percentage of the associated
exposure guideline power density,
either referenced to the E or H field.
fall being detected an alarm will
sound which can only be cleared
by switching the device off and on
again.
The device will automatically switch
‚
off after 8 hours to ensure that
the device is not inadvertently left
switched on causing the batteries to
drain unnecessarily.
Data points are stored at up to once
‚
every second in a changing field. In
static field conditions or below the
device noise floor fewer points are
stored to conserve memory.
A 6-minute average is also
‚
calculated and stored.
These values can be accessed by
‚
using the FieldSENSE app, available
from www.fieldsense.com.
3
Publicidad
