Publicidad
Idiomas disponibles
Idiomas disponibles
2. Gently remove the blade by lifting the end tip of the blade off
of the grass shear + hedge trimmer unit (Fig. 4).
Fig. 4
3. Insert the desired blade into the base of the motor housing
(Fig. 5).
Fig. 5
NOTE: You may need to manually move the blade or gear shaft
in order to align the gear shaft with the gear in the center of the
unit.
4. Align the gear shaft in the middle of the blade with the gear
in the middle of the unit. Align the four (4) lugs so
that the blade lays flat against the housing for a secure
fit (Fig. 6).
Fig. 6
Lugs
Lugs
5. Once the blade is in position, replace the blade cover by
aligning the cover with the slots on the base of the motor
housing (Fig. 7).
6. Push forward on the blade cover until it slides and clicks into
place (Fig. 8). The grass shear + hedge trimmer is now ready
for use.
NOTE: If you have any questions, please call the
All Season Power customer service department at
1-866-225-9723 for assistance.
Before Using
Charging Procedure
The battery charger supplied matches the lithium-ion battery
installed in the tool. Do not use other battery chargers.
The lithium-ion battery is protected against deep discharging.
When the battery is empty, a protective circuit will automatically
Gear shaft
switch OFF the machine. The blade will no longer move and a
slight whistling sound will be heard.
Charge the battery for 5 to 7 hours, then use it until it runs down
(i.e. the tool starts to operate slowly). Recharge for
5 to 7 hours again before resuming operation.
m
WARNING!
OFF trigger switch can permanently damage the lithium-ion
battery.
8
Fig. 7
Fig. 8
Continued and excessive overuse of the ON/
Publicidad
