Klarfit Goldie Home Manual Del Usuario página 20

EN
2. Bicycles with Quick Release Axle
Remove the quick release from the bike and guide it through the hitch along with the quick
release axle. Push the quick release through the wheel hollow axle again, screw the nut and
clamp the quick release with the correct pressure.
In order to ensure that the hub is clamped sufficiently in the hollow axle, the quick release lever
must begin gripping as it moves from the open to the middle position, and approaching the
closed position you should clearly feel resistance as you tighten. If it is too easy or too difficult
to move the quick release lever, tighten or loosen the quick release nut on the other side of the
hub.
20
WARNING!
Danger of serious injury or death
• The axle nut must be tightened on the axle thread by at least 5 full
turns, so that adequate clamping force is ensured. A thread which is too
short can result in accidental loosening of the rear wheel and therefore
cause serious injury or death.
• Wrap the safety strap around the chain stay and fasten it to the tow bar
D-ring with the snap hook.
WARNING!
Danger of serious injury or death
Hitch and safety strap must be properly installed. Inspect the hitch and tow
bar frequently for any damage or loose fasteners. Damaged or improperly
installed can result in serious injury or death.