ProfiCare PC-BS 3085 A Manual De Instrucciones página 54

The higher flow speed of the container allows for heavy
dirt and smallest floating particles to be separated from the
"sucked-in air".
It is thus not necessary to buy dust bags.
The filters must be cleaned periodically.
CAUTION:
• Never wash the filter in the washing machine.
• Never immerse the dust container in water. Do not
rinse it out with water either. This could destroy the
electronics.
• Do not use a hair-dryer for drying.
• Only put the appliance back into operation when all
filters are completely dry and correctly assembled.
The Filter Unit
The filter unit is located in the dust container and consists
of:
• HEPA-filter
• Coarse filter
Proceed as follows to clean the filter unit:
1. Empty the dust container as described above.
(Steps 1 - 5)
2. Disassembly of the Filter Unit
2.1 Hold the appliance by the handle with your left hand.
Note the symbols (three dots) on the appliance.
Slide the dust container release (18) and simulta-
neously turn the dust container to the left. The ●
symbol on the dust container is now located below
the left ● symbol on the handset. The dust container
can now be separated from the housing.
WARNING:
• Always disconnect the appliance from the power adapter before
cleaning!
• Under no circumstances should you immerse the motor housing
in water in order to clean it. Otherwise this might result in an
electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• The single components are not dishwasher-safe.
54
PC-BS3085A_IM_new
2.2 Remove the HEPA filter by pulling the "UP" flag.
2.3 Pull the coarse filter out of the dust container using
the handle. The grip of the handle is located on the
side of the release (18).
3. Cleaning the Filters
3.1 Hold both filters over a garbage can and tap out the
dust. You may also brush out the HEPA filter. In case
of heavy staining, clean the filters under running
water.
3.2 Let the filters air-dry completely before refitting them!
3.3 Wipe the dust container with a damp cloth and then
wipe it dry.
4. Assembly of the Filter Unit
4.1 Place the coarse filter in the dust container. Note
the recesses in the dust container. Do not apply
too much force when inserting the coarse filter,
otherwise it will be difficult to remove.
4.2 Place the HEPA filter back into the coarse filter. The
"UP" flag must point upwards.
4.3 Then reattach the dust container to the handset.
Attach the dust container to the handset with the ●
symbol on the dust container positioned below the
left ● symbol on the handset. Then turn the dust
container to the right up to the stop. The ● symbol
on the dust container now has to be located below
the right ● symbol on the handset. The connection
must audibly engage.
Cleaning
• Wipe the casing with a damp cloth.
• You can wipe the power adapter appliance with a dry
cloth.
07.07.21