Publicidad
Idiomas disponibles
Idiomas disponibles
Setup
Your universal remote requires two (2) AAA
batteries (not included). Alkaline batteries are
recommended.
Battery installation
1. On the back of the remote, pull down on
the textured surface and slide battery cover
downward to remove.
2. Match the (+) and (-) marks on the batteries
to the (+) and (-) marks inside the battery
compartment, then insert two (2) AAA
batteries. Be sure to use fresh batteries.
3. Position battery cover slightly below opening
and push upward to lock into place.
NOTE: If your remote stops operating properly,
replace the batteries with new ones.
Battery precautions
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
• Always remove old, weak or worn-out
batteries promptly and recycle or dispose of
them in accordance with local and national
regulations.
Battery saver
Your remote automatically turns off if the buttons
are held down for more than 8 seconds. This will
save your batteries should your remote get stuck
in a place where the buttons remain depressed
(e.g., between sofa cushions).
Code saver
You have up to 10 minutes to change the batteries
in your remote without losing the codes you have
programmed.
SRP4229B_07 ENG Manual v2.indd 3
SRP4229B_07 ENG Manual v2.indd 3
3
9/2/21 5:03 PM
9/2/21 5:03 PM
Publicidad
