Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
Refrigerat0
Models 18 and 19
I ffyou have questions,call 1.800.GE.CARES o r visitourWcbsite a t: www.GEAppliances.com
I
BEFORE YOU BEGIN
Read these
instructions
completely
and carefully.
• IMPORTANT - Save these
instructions
for local inspector's
use.
• IMPORTANT
- Obso ,,c all
governing
codes and ordinances.
• Note to Installer
-
Be sure
to leave these
instructions
with the Consumes:
• Note to Consumer
- Keep
these
instructions
for future reference.
• Skill level - Installation
of this appliance
requires
basic
mechanical
skills.
• Completion
time -
Refrigerator
Installation
15 minutes.
• Proper installation
is the responsibility
of the
installer.
• Product failure due to improper
insmllatlon
is not
covered
under the Warranty.
WATER SUPPLY TO THE ICEMAKER
(ON SOME MODELS)
If the refrigerator
has an icemakm,
it will have m be
connected
m a cold water line. A GE water supply kit
(containing
tubing, shutoff valve, fittings and
instructions)
is available at extra cost from your dealer
or by visiting our Website at www.GEAppliances.com
or Parts and Accessories,
800.626.2002.
REFRIGERATOR
LOCATION
• Do not install the refrigerator
where the temperature
will go below 60°F (16°C) because it will not run often
enough to maintain
proper temperatures.
• Do not install the refiigerator
where the temperature
will go above 100°F (37°C) because it will not perform
properly.
• Install it on a floor strong enough to support it fully
loaded.
CLEARANCES
Allow the following
clearances
for ease of installation,
proper
air circulation
and plumbing
and electrical
connections.
• Sides 1/8" (3 mm)
• Top 1" (25 mm)
• Back 1" (25 mm)
If the refligerator
is to be installed next to a wall on the
hinge side, allow 5/16" (8 mm) door clearance.
ROLLERS
(ON SOME
MODELS)
The rogers
have 3 purposes:
• Rollers adjust so the door closes easily when opened
atzu0ut45 °.
• Rollers adjust so the refiigerator
is firmly positioned
on
the floor and does not wobble.
• Rollers allow you to move the refrigerator away from the
wall for cleaning.
NOTE: When rollm.'s are properly adjusted, the top of the
refiigerator
will not be level but will have a slight backward
tilt.
To adjust the rollers,
remove
the base grille by grasping
it
about 6 inches
from each end
and pulling
its bottom
edge
toward you.
Turn the two front roller
adjusting
screws clockwise
to raise the front
of the
refiigerato_;
counterclockwise
to lower iu
Replace the base g_lle by
___
inserting the tops of the
metal clips into the oval
vents, making sure one of
the plastic tabs on the back
of the grille goes into each of
the o'¢alvents. Then push the bottom of the grille fbru_ard
until it snaps into place.
13
Publicidad
