Publicidad
16
2600-VCO
2600-VCO Controls
(CN) 控制
INITIAL OSCILLATOR
(1)
FREQUENCY
– 选择压控振荡
器的初始频率。 在音频模式
10
10
下, 范围为
赫兹至
千赫
0.03
兹; 在低频模式下, 范围为
30
赫兹至
赫兹.
FINE TUNE
2600 VCO
(2)
– 允许
调
谐到其他压控振荡器或仪
± 0.4
表, 控制器具有
八度
的范围。
PULSE WIDTH
(3)
– 允许手动控制
脉冲波形的宽度,
10%
90%.
范围为
至
OUTPUTS
– 正弦波, 三角波, 锯
(4)
齿波和脉冲波的独立输出。
所有输出均可同时使用
KEYBOARD CV INPUT
(5)
– 接受来
MIDI/CV
自键盘或
转换器的控
0
10
制电压, 范围为
伏–
伏
FM INPUTS AND LEVELS
(6)
(7), (8)
-
– 压控振荡器的调频输入加
上控制调制电平的衰减器
PULSE WIDTH MODULATION
(9)
INPUT AND LEVEL
– 脉宽波形
宽度的外部调制源输入, 加上
控制调制电平的衰减器
KEYBOARD ON/OFF SWITCH
(10)
–
允许关闭键盘电压, 从而将压
控振荡器置于低频模式
Power Connection
P1
Red Stripe
2
1
10
9
200 mm ± 10
Connect end P1 to the module socket
Connect end P2 to the power supply
The 2600-VCO module comes with the required power cable for connecting to a
standard Eurorack power supply system. Follow these steps to connect the module
to your Eurorack case.
1. Turn the power supply or rack case power off and disconnect the power cable.
2. Insert the 16-pin connector on the power cable into the socket on the power
supply or rack case. The connector has a tab that will align with the gap in the
socket, so it cannot be inserted incorrectly. If the power supply does not have a
keyed socket, be sure to orient pin 1 (-12 V) with the red stripe on the cable.
3. Insert the 10-pin connector into the socket on the back of the module. The
connector has a tab that will align with the socket for correct orientation.
4. After both ends of the power cable have been securely attached, you may mount
the module in a case and turn on the power supply.
Installation
The necessary screws are included with the module for mounting in a Eurorack case.
Connect the power cable before mounting.
Depending on the rack case, there may be a series of fixed holes spaced 2 HP apart
along the length of the case, or a track that allows individual threaded plates to
slide along the length of the case. The free-moving threaded plates allow precise
positioning of the module, but each plate should be positioned in the approximate
relation to the mounting holes in your module before attaching the screws.
Hold the module against the Eurorack rails so that each of the mounting holes are
aligned with a threaded rail or threaded plate. Attach the screws part way to start,
which will allow small adjustments to the positioning while you get them all aligned.
After the final position has been established, tighten the screws down.
17
Quick Start Guide
P2
1
2
HOT USED
15
16
+ 12V
+ 12V
GROUND
GROUND
- 12V
- 12V
Publicidad
