Bresser ClimateTemp NDH-NEO Manual De Instrucciones página 23

different channel. If only one remote sensor is
connected, it should be operated on channel 1.
4. Replace the battery compartment cover.
9. Time Setting
After the power is restored, the unit automatically
searches for the radio signal. It takes approximately
3-8 minutes for this process to complete.
If the radio signal is received correctly, the date and
time are set automatically and the reception symbol
is displayed.
If no radio signal is received, proceed as follows:
1. Press and hold the
for approx. 3 seconds to activate reception of the
radio signal. Reception is now initialized again.
2. If still no radio signal is received, the time must
be set manually.
Manual time setting:
1. Press and hold button for approx. 3 seconds
to enter to the time setting mode.
button on the base unit
2. Digits to be set are flashing.
3. Press or button to change the value.
4. Press button to confirm and continue to the
next setting.
5. Settings order: Time zone>12/24H format>Hour
> Minute>DM/MD> Year> Month>Day>Week
language
6. Finally press the
and exit the setting mode.
In normal mode, press
temperature unit in C or F.
10. Alarm setting
1. In normal mode, press
alarm time.
2. When check the alarm time, press
again to turn on or turn off the alarm.
3. When enter the alarm mode, press and hold
the button for approx. 3 seconds to enter
button to save the settings
button to select the
button to check the
button
EN
23