Waterdrop WD-AS13 Manual De Instrucciones página 4

Installation of the Filter System
1. Connect the inlet hose and the outlet hose to the filter head. (Figure 1) When the tubing
is fully inserted, put the blue lock clip on the fitting. It will lock the tubing in place and prevent
it from falling off.
2. Shut off the water supply. Remove the faucet hose. (Figure 2)
3. Connect the inlet hose to the cold water valve.
• If the angle valve outlet is 3/8", it can be directly connected to the water supply. (Figure 3)
• If the angle valve outlet is 1/2", connect it with a converter No.1 at first. (Figure 4)
3/8" outlet
4. Connect to the faucet
• If the faucet hose is 3/8", it can be directly connected to the outlet hose. (Figure 5)
• If the faucet hose is 1/2", connect it with a converter No.2 at first. (Figure 6)
Faucet hose
Outlet hose
NOTE: If a female threaded connector is needed, please contact our service team for help.
2
Figure 1
Figure 3
Figure 5
Figure 2
1/2" outlet
Connect No.1 to the cold angle valve
Faucet hose
Converter No.2
Converter No.1
Figure 4
Figure 6