Waterdrop WD-AS13 Manual De Instrucciones página 6

Unscrew Screw
Figure 7 Figure 8 Figure 9
Warnings
1. Do not use with water above 100˚F/38˚C.
2. Flush the filter for 3-5 minutes before the first use or after filter replacement.
3. If the system has not been used for over 24 hours, run water for 1 minute before use.
4. Do not touch the filtered water outlet of the system in order to prevent bacteria from
building up.
5. Protect the filter system from freezing temperatures, frost, snow, sleet, and ice.
6. Clean the exterior of the system with a soft cloth to maintain its appearance and service life.
7. Replace the filter every 12 months or 8, 000 gallons for best filtration performance.
Frequently Asked Questions
Q: What should I do if water leaks after installation?
A: In the event of water leakage, turn off the water supply. If the water leakage is occurring at
the thread, wrap the Teflon tape around the external thread. If the water leakage is occurring
at the quick connection position, insert the quick-connect fitting to the end and make sure the
hoses hit the bottom of the fitting. Contact us for solutions if the water leakage persists.
Q: Why does the TDS value not decrease after filtration?
A: The main purpose of this waterdrop filter is not to remove TDS. TDS stands for total
dissolved solids, and it is basically composed of inorganic salts and a small amount of
organic matter. The filter can remove harmful substances while keeping beneficial trace
elements. Please choose Waterdrop RO system if you are looking for physical removal of TDS.
Q: When should I replace the filter?
A: The filter's service life is related to water quality. If the flow rate is significantly reduced or if
the water has a peculiar smell, we suggest that you replace the filter.
Q: Why does black water come out during flushing?
A: It's normal that black water comes out when flushing. The purpose is to remove carbon
powder remaining on the surface of filter materials. You can normally use it after flushing for
5 minutes.
4