Zycoo SH10 Guía De Instalación Rápida página 4

Installation
1
Separate the speaker and the pedestal.
2
Use an 8 mm drill to drill 3 mounting holes for the pedestal as shown in Figure 1.
3
Push the anchors into the mounting holes and tighten then with a rubber hammer.
4
Install the pedestal to the mounting holes and fix with KA5*45 screws.
5
Install the horn speaker back to the pedestal and tighten the bolt.
6
Loose the angle adjustment knob to adjust the speaker angle, after you get a perfect
angle, then tighten the knob.
7
Connect network cable and power supply.
1
English
120°
φ64.0mm
φ5.0mm
Figure 1
Speaker Fixing Bolt
Angle Adjustment Knob
Pedestal