Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
SAFETY
1. Read this owners manual and the vehicle owners manual before
using this sprayer.
2. Never allow children to operate this sprayer.
3. Do not allow anyone to ride on or sit on this sprayer.
4. Keep the area clear of all persons, especially small children.
5. Read the chemical label before handling or mixing chemicals.
6. Wear eye and hand protection and protective clothing when
handling and applying lawn chemicals.
7. Do not spray on windy days.
8. Be aware of your tractor's capabilities. Attaching this sprayer may
affect your tractor's braking and stability.
9. STAY OFF STEEP SLOPES. Refer to the vehicle owner's manual
concerning safe operation on slopes.
10. Operate at reduced speed on rough terrain, along ditches and on
hillsides to prevent loss of control.
ASSEMBLY
The meanings of symbols used in the illustrations are as follows:
Do not tighten yet.
OPERATION
CAUTION: Connect to a 12 V battery only.
PUMP PRESSURE SWITCH
The pump pressure switch turns off the pump when it reaches
its maximum pressure setting. Very low flow demand may cause
the switch to rapidly cycle the pump on and off. Rapid on and off
cycling must be limited to no more than 6 times per minute. Cycling
could cause the motor to heat beyond the recommended maximum
temperature and reduce the operational life of the pump and pressure
switch.
SPRAYER CONTROLS
Boom ON-OFF valve shuts off the flow to the boom nozzles.
Boom
Valve
ADJUSTABLE SPRAY WAND NOZZLE
Twisting the nozzle will adjust the spray pattern from a cone shaped
mist to a solid stream.
Tighten now.
BEFORE STARTING
1. Attach the sprayer to the tractor hitch.
2. Connect the wire harness from the switch to the pump.
3. Check for leaks using plain water. Fix leaking fittings with
thread tape.
USING THE SPRAYER
CAUTION: Wear eye and hand protection and protective
clothing when handling and working with lawn chemicals.
1. Determine the application rate (gallons per 1,000 sq. feet) based on
the chemical manufacturers recommendations.
2. Estimate the size of the area to be sprayed and the amount of
solution that will be needed. This can help avoid unneeded solution
left in the tank.
3. Refer to the application chart below to help determine the speed
required to achieve the manufacturers recommended application
rate.
4. Check height of spray tips to top of spray target is approximately
15" (43 cm). If necessary, adjust boom height by raising or lower
the boom on the threaded boom supports.
5. Use plain water to check the spray pattern. Refer to maintenance
section for how to clean and adjust spray tips.
6. Add the chemical solution to the tank, following the manufacturers
recommendations.
7. Begin spraying by turning switch to "ON", making each pass so
that the spray pattern slightly overlaps the spray pattern from the
previous pass.
8. Stay clear of flowers, shrubs and evergreen trees when spraying to
prevent contact of the solution with these sensitive plants.
APPLICATION CHART
Sprayer
Tip Size
0.4 GPM
15 Gallon
110 deg
Sprayer
2 mph
15 Gallon
0.95
USING THE SPRAY WAND
1. Shut off the boom by turning the boom valve to "OFF".
2. Squeeze handle on spray gun.
4
40"
30"
1 m
.75m
70"
80"
2 m
1.78m
PSI
GMP One Nozzle
45
0.42
Gallons per 1000 Sq. Ft.
3 mph
4 mph
5 mph
0.63
0.48
0.38
15"
14"
35 cm
43cm
6 mph
0.32
Publicidad
