Rack Features; Dishwasher Cycles And Options - Bosch SPE5ES55UC Manual De Uso

Rack Features

Flip Tines
The racks consist of tines that can be folded down depending on what you
may need to load in the rack. To fold down, grasp the folding tine and
release from notch. Push folding tine downward to desired position as
shown in Figure 6.
3-Step RackMatic®
The height of the upper rack can be adjusted in 3 steps to create more space.
Pull the empty top rack out of the dishwasher until it stops.
1
To lower the rack, push the lever inward then upward.
2
To raise, hold the emtpy rack by the sides and lift up.
3
Note: Before pushing the top rack into the dishwasher, ensure the rack height
is the same on both sides. If the height is not the same on both sides, the dish-
washer door will not shut and the top rack spray arm will not connect to the
water inlet.

Dishwasher Cycles and Options

Wash Cycles
Heavy: Best for cleaning items with baked-on food or grease. These dishes would normally require soaking.
Auto: This is the most flexible cycle and is a good choice for everyday use. With our most complex soil
sensing capability, this cycle is perfect for use with mixed loads of dishware with varying amounts of
food soil.
Normal: Thoroughly cleans a full load of normally soiled dishes.
Note: The Energy Guide Label was based on this soil sensing cycle with all available options turned off. As
prescribed in the energy test procedure, the unit was tested without any Rinse Aid in the Rinse Aid dis-
penser. A single dose of detergent was used in the Detergent Dispenser, with no detergent used in the pre-
wash. The test was conducted with the upper rack in the highest position.
Rinse: Allows you to rinse food soil off of a partial load and hold them in the dishwasher until you are
ready to run a full load.
Wash Cycle Options
Delay Start: Allows you to delay the start time of your dishwasher in one hour increments up to 24 hours.
Half Load: In the Heavy, Auto and Normal wash cycles, the Half Load option can reduce the energy and
water consumption when washing small, lightly soiled loads that fill approximately half of the dishwasher's
capacity. To activate, select the Half Load button in addition to any of the three cycles listed above.
Sanitize: The Sanitize feature is available only in the Heavy, Auto and Normal cycles. Select one of these
cycles, press the "Sanitize Option" button and then press Start to activate the Sanitation features. The
sanitize LED will light when sanitation requirements are met. The technical sanitation measures may also
improve the drying results.
Note: The dishwasher automatically defaults to Auto when turned off and back on. If you used the sanitize
option in your last cycle, the dishwasher will default to Auto with the Sanitize option selected when you turn
it on.
8
Figure 6
1
2
Figure 7