Publicidad
Idiomas disponibles
Idiomas disponibles
4 BEFORE USING THE APPLIANCE
Preparing your dishwasher for first use
•
Make sure the electricity and supply water
specifications match the values indicated in
the installation instructions for the machine.
•
Remove all packaging material inside the
machine.
•
Fill the rinse aid compartment.
Detergent usage
Only use detergents specifically designed for
domestic dishwashers. Store detergents in cool,
dry places out of reach of children.
Add the proper detergent for the selected cycle
to ensure the best performance. The amount of
detergent needed depends on the cycle, load
size, and soil level of dishes.
Do not overfill the detergent compartment.
Using too much detergent can cause
discoloration on glasses and dishes and glass
corrosion. Continued use of too much detergent
may cause machine damage.
Using too little detergent can result in poor
cleaning and whitish streaks, especially in hard
water.
See the detergent manufacturer's instructions for
a further information.
Filling the detergent
Push the latch to open the dispenser and pour in
the detergent.
Close the lid and press it until it locks in place.
The dispenser should be refilled just before the
start of each cycle. If the dishes are heavily
soiled, place additional detergent in the pre-
wash detergent chamber.
Using detergent pacs
These products should be used according to the
manufacturer's instructions.
Never put detergent pacs into the interior
section or the cutlery basket.
Detergent pacs contain not only the detergent
but also rinse aid, salt replacement substances
and additional components depending on the
combination.
We recommend you do not use detergent pacs
in short cycles. Please use powder or liquid
detergents instead of detergent pacs in short
cycles.
If you encounter problems when using detergent
pacs, please contact the detergent manufacturer.
When you stop using detergent pacs, make sure
that rinse aid setting is set to the correct level.
Rinse-aid usage
The rinse aid helps to dry the dishes without
streaks and stains. Rinse aid is required for
stain-free utensils and clear glasses. The rinse
aid is automatically released during the hot
rinse phase. If rinse aid setting is too low, whitish
stains remain on dishes and dishes do not dry or
wash clean.
If rinse aid setting is too high, bluish layers on
glasses and dishes may be seen.
Filling the rinse-aid and setting
To fill the rinse aid compartment, open the rinse
aid compartment cap. Fill the compartment
with rinse aid to the MAX level and then close
the cap. Be careful not to overfill the rinse aid
compartment and wipe up any spills.
In order to change the rinse aid level, follow
the below steps
•
Press the Cycles button and hold it down
when the machine is off position.
•
Turn on the machine by pressing On/Off
button and continue to press Cycles button
DETERGENT
until "rA" disappears from the display.
•
The machine will display the last setting.
•
Set the level by pressing the Cycles button.
•
Turn off the machine to save the setting.
The factory setting is "4".
If the dishes are not drying properly or are
spotted, increase the level. If blue stains form on
your dishes, decrease the level.
USA - CAN - 13
Publicidad
