Publicidad
Idiomas disponibles
Idiomas disponibles
comfortable washing with conditions specific to
you.
i. Auxiliary options may cause changes in the
program duration.
ii. Auxiliary options are not suitable for all
washing cycles. Indicator of the auxiliary
option that is not compatible with the
program will not be active.
The compatibility of the cycles and
options is shown on the "Cycles and Options
Table" section.
To add auxiliary option to the cycle :
1. Select the desired washing cycle pressing
the Cycles Button key.
2. In the selected washing cycle, if auxiliary
option is selected, the corresponding option
led will be on. If the Half Load or Options
button is pressed again, the corresponding led
of another auxiliary option will be on. To
select the High Temp function, press Options
button for 3 seconds.
3. The selection of the auxiliary option will
be cancelled when you press the Half Load
or Options button until the selected option led
becomes off.
Sani Rinse Option
Sani Rinse option raises the water temperature in
the final rinse.
i. If the cycle selected with the Sani Rinse option
is successfully sanitized, sanitized indicator
lights up at the end of the cycle.
ii. Available cycles and options are
indicated on Cycles and Options Table
Accela Wash Option
Select the Accela Wash option to help decrease
the duration of a cycle by raising water
temperature and pressure.
Extra Dry Option
The machine changes the water temperature from
the value described for each different program
and the extra dry is performed.
Half Load Option
There is a half load option with three modes.
Use the half load feature to direct cleaning to
the desired rack when the dishwasher is not fully
loaded. When the half load option is selected
by pressing Half Load button, the indicator(s) on
the control panel will illuminate according to the
selections. If the top rack half load and bottom
rack half load indicators are selected together,
this will shorten the length of cycle and reduce
energy and water consumption.
High Temp Option
When High Temp option is selected by pressing
Half Load button during 3 seconds, both the
water temperature and the washing time are
increased.
Delay Hours Option
The start time of the cycle can be delayed for
1-19 hours by pressing Delay Hours. When the
Delay Hours button is pressed, the display will
show "1h." The display will alternate between
the delay time and the cycle duration every two
seconds. The delay time will increase in one hour
increments with every push of thd Delay Hours
button. When the desired delay hours has been
set, press the Start/Pause button.
NOTE: If the dishwasher door is opened during
the delay period and closed within four seconds,
the dishwasher will resume counting down the
delay period. If the door is opened for more
than four seconds, the delay timer is paused. To
resume the delay timer, close the door and press
the Start/Pause button.
Control Lock
Control Lock can be turned on by pressing and
holding the 'Options' and Half Load / High Temp
buttons for 3 seconds. When Control Lock is
activated all LED's flash on the machine and "CL"
is shown on the display. To deactivate the Control
Lock repeat the above instructions, all LED's and
"CL" flash twice and then remain off.
Cancelling a Cycle
If you would like to cancel a cycle when it is
running. Press the Start/Pause button for 3
seconds. During cancellation, the End indicator
blinks. The machine discharges the water inside
it in about 30 seconds. When the End indicator
turns on, switch your machine off by pressing the
On/Off button.
USA - CAN - 22
Publicidad
