f2
f3
L
12
GB
TOPPING UP THE OIL-DYNAMIC CIRCUIT ( g. f8)
You need to top up the oil-dynamic circuit after a long period
of work (15000 cycles), when you note a power loss. Put the
riveting tool ( D WELL AND NOT FED ) in a horizontal position and
remove the plug ( E) and the nozzle ( A ) using the appropriate
wrenches provided with the tool. During this operation, check
the oil level in order to avoid any over owing. Then, slowly
pour the oil HLP 32 cSt into the bellows container ( O) which
shall be screwed to its seat on the plug ( E). While keeping the
riveting tool in a horizontal position and starting air feeding,
push the tensile strength button and make the riveting tool
carry out some cycles until air bubbles inside the container (
stop coming out. This condition indicates that the topping up of
D
the oil has fully been achieved. At this point, while keeping the
riveting tool in a horizontal position, unscrew the oil container
(O) and close it again.
Do not push the tensile strength button during this operation.
Go on by closing the oil tank plug ( E).
WARNING: it is very important to follow the about mentioned
instructions and use gloves and protection glasses or protective
visors. If you need to empty fully the hydraulic circuit, you must
put the oil in a suitable container and contact a Company that
is authorized to discharge any waste.
75036036 - RAC172 – rev 03 - ( 12-2021 )
ATTENTION!
Before disconnecting the compressed air hose,
make sure that it is not under pressure!
ATTENTION: Make sure that the oil ller cap ( E ) is
tightened at a torque corresponding to
min. 5 Nm ÷ Max. 8 Nm.
We recommend to use oil HLP 32 cSt or similars.
E
A
min. 5 Nm
max. 8 Nm
f8
O)
O