GE Profile 23 Manual Del Propietario E Instalación página 32

Installation Instructions
INSTALLING THE WATER LINE
{ICEMAKER
&DISPENSER
MODELS}
BEFORE YOU BEGIN
Recommended copper water supply kits are WX8X2,
WX8X3 or WX8X4, depending on the amount of tubing
you need. Approved plastic water supply lines are GE
SmartConnect T"Refrigerator Tubing (WXO8XZO006,
WX08X!00!5 and WX08X!0025),
When connecting your refrigerator to a GE Reverse
Osmosis Water System, the only approved installation
is with a GE RVKit, For other reverse osmosis water
systems, follow the manufacturer's recommendations,
If the water supply to the refrigerator is from
a Reverse Osmosis Water Filtration System
AND the refrigerator also has a water filter,
use the refrigerator's filter bypass plug, Using
the refrigerator's water filtration cartridge in
conjunction with the RO filter can result in hollow
ice cubes and slower water flow from the water
dispenser,
This water line installation is not warranted by
the refrigerator or icemaker manufacturen Follow
these instructions carefully to minimize the risk
of expensive water damage.
Water hammer (water banging in the pipes) in
house plumbing can cause damage to refrigerator
parts and lead to water leakage or flooding. Call a
qualified plumber to correct water hammer before
installing the water supply line to the refrigerator.
To prevent burns and product damage, do not hook
up the water line to the hot water line.
If you use your refrigerator before connecting
the water line, make sure the icemaker power
switch is in the O loft} position,
Do not install the icemaker tubing in areas where
temperatures fall below freezing,
When using any electrical device (such as a power
drill) during installation, be sure the device is double
insulated or grounded in a manner to prevent the
hazard of electric shock, or is battery powered.
All installations must be in accordance with local
plumbing code requirements,
WHAT YOU WILL NEED
J
• Copper or GE SmartConnect" Refrigerator
Tubing kit, 1/4" outer diameter to connect the
refrigerator to the water supply, If using copper,
be sure both ends of the tubing are cut square.
To determine how much tubing you need:
measure the distance from the water valve on
the back of the refrigerator to the water supply
pipe. Be sure there is sufficient extra tubing to allow
the refrigerator to move out from the wall after
installation.
GE SmartConnect T"Refrigerator Tubing Kits are
available in the following lengths:
6' (1.8 m) - WX08X10006
15' (4.6 m) - WXO8X10015
25' (7.6 m) - WXO8X10025
32