2.2
Temperature control panel
Recommended
gear
(The above pictures are for reference only, and the actual configuration shall be subject to the actual
purchase or the seller's statement)
2.3
Placement
Recommended
gear
Before using the freezer,
please remove all the
package, which includes
the base pad, the foam
cushion block in the
freezer and adhesive
tape, etc. And tear off
the protective film on the
door body and case.
Select the place that is
far away from the heat
source and direct
sunlight Do not place it
in damp or watery areas
to prevent rusting or
weakening the insulation
effect.
After power on the "POWER" indicator light will be light( green ).
The area where the temperature controller knob points to
"COOLING" is the refrigeration area, and "FREEZING" is the
frozen area;
When the temperature controller knob is turned clockwise,
the temperature inside the freezer decreases;
When the temperature controller knob is turned
counterclockwise, the temperature inside the freezer
increases;
Please refer to the schematic diagram to identify the
"recommended gear".
EN-7
Place the freezer in a
well-ventilated indoor
area with a flat and
sturdy ground.
The top space of the freezer
should be greater than 70cm
and the distance between the
sides and back of the freezer
and the wall should be greater
than 20cm, so as to facilitate the
opening and closing of the
freezer door and heat dissipation.