Streifeneder ortho.production 3A40 Instrucciones De Uso página 9

Fig. 2
SACH-Foot
Dynamic Foot
Limitation of flexion
„
The product allows a knee flexion of 135°. However, this flexion angle can only be achieved
with a correctly fabricated socket/prosthesis alignment. With a correct prosthetic alignment,
it can be assumed that the user's buttock touches the prosthetic foot before the socket comes
into contact with the knee joint.
Technical Notes
„
The tightening torque for the Socket screws (fig. 5) is 16 Nm with the 173P11 Torque
Wrench, calibrated.
Please take special care, that this product is not exposed to corrosive chemicals and
substances such as salt- and freshwater, acids, dust or sand! Failure to observe these
instructions will make any claims against Streifeneder ortho.production GmbH null
and void.
Please inform your patient accordingly!
To eliminate sounds in the cosmetic soft foam cover, use Silicone Parting Agent Spray.
Do not use talcum powder! Using talcum powder increases the risk of the patient falling,
as talcum powder withdraws grease from the mechanical components and therefore
function may be inhibited. If the product is used with talcum powder, all claims against
Streifeneder ortho.production are null and void. Spray the Silicone Parting Agent Spray
directly onto the friction surfaces of the cosmetic soft foam cover.
Furthermore, when using a foam cosmetic, make sure that it does not get stuck
between the moving parts of the knee joint, as this can lead to a fall.
The lock audibly engages and may be easily released by means of the lock cord. The lock cord
should be attached laterally at the prostheses, fixed to the cord guide of the lock clamp. The
cord guide can shifted at on the lock clamp (fig. 3).
Lock Mechanism Adjustment
„
The Knee Joint has been factory inspected and set for immediate use. The stop screw is secured
with Loctite 241 screw retention. Slight play does not result in functional disadvantages.
In order to adjust the extention stop screw, please stick to following steps:
Remove the plastic ring by means of a screwdriver or by hand from the plastic knee cap (fig. 4).
Disengage the lock mechanism and flex the knee (fig. 5). Adjust the play of the stop using a 6 mm
allen key (fig. 6).
By turning the stop screw clockwise, the play increases. Turning the stop screw counterclock-
wise results in a decreased play.
Heel height
10 (± 2) mm
18 (± 2) mm
10 (± 5) mm
Distance (d)
10 – 15 mm
10 – 20 mm
9/16