Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts are
replaced. Please contact customer service or a qualified
service center for assistance.
APPLICATIONS
You may use this product for the purpose listed below:
„ Trimming grass and weeds from around porches, fences,
and decks when using with the trimmer line.
LINE TRIMMING CUT-OFF BLADE
See Figure 9.
WARNING:
The line cut-off blade on the grass deflector is sharp.
Avoid contact with the blade. Failure to avoid contact
can result in serious personal injury.
The trimmer is equipped with a line trimming cut-off blade on the
grass deflector. For best cutting, advance line until it is trimmed
to length by the cut-off blade. Advance the line whenever you
hear the motor running faster than normal, or when trimming
efficiency diminishes. This will maintain best performance and
keep the line long enough to advance properly.
OPERATION
NOTICE:
Failure to attach the grass deflector prevents the line
being cut to the proper length and can cause tool failure.
The wingnut, located on the guard rail of the trimmer, is used
to adjust the cutting swath.
To increase the cutting swath:
„ Stop the motor and disconnect from the power supply.
„ Loosen the wingnut counterclockwise to adjust the guard
rail.
„ Slide the guard rail backward (16 in. is the rear-most
position).
„ Turn the wingnut clockwise and tighten to set the cutting
swath.
To decrease the cutting swath:
„ Stop the motor and disconnect from the power supply.
„ Loosen the wingnut counterclockwise to adjust the guard
rail.
„ Slide the guard rail forward (14 in. is the forward-most
position).
„ Turn the wingnut clockwise and tighten to set the cutting
swath.
OPERATING THE TRIMMER
See Figure 10.
WARNING:
The motor housing on power heads may become hot
during trimmer operation. Do not rest or place your arm,
hand, or any body part against the motor housing dur-
ing trimmer operation. Only hold the trimmer as shown
in figure 10, with all body parts clear of motor housing.
Extended contact with the motor housing can result in
burns or other injuries.
WARNING:
Always position the unit on the operator's right side. The
use of the unit on the operator's left side will expose the
user to hot surfaces and can result in possible burn injury.
WARNING:
To avoid burns from hot surfaces, never operate unit with
the bottom of the motor above waist level.
Hold the trimmer with your right hand on the rear handle
and your left hand on the front handle. Keep a firm grip with
both hands while in operation. Trimmer should be held at a
comfortable position with the rear handle about hip height.
7 — English
Publicidad
