Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
Burners burn with a yellow or orange fl ame, in
conjunction with the smell of gas.
Burner does not light, or fl ame is low in "HI"
position.
Experiencing fl are-ups:
CAUTION: Do not line the bottom tray with
aluminum foil.
Burner fl ame pattern is erratic. Flame is low when
burner is on "HI." Flames do not run the whole
length of the burner tube.
Inside of lid appears to be "peeling." (Resembles
paint peeling.)
Cabinet doors are not aligned.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com
®
.
PROBLEM
Side Burner does not light.
Flame is low in "HI" position
Push button ignition does not work.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
®
site. Log onto www.weber.com
.
WWW.WEBER.COM
®
TROUBLESHOOTING
Inspect Spider / Insect Screens for possible obstructions.
(Blockage of holes.)
Is fuel hose bent or kinked?
Does the burner light with a match?
Are you preheating barbecue in the prescribed manner?
Are the cooking grates and Flavorizer
coated with burned-on grease?
Is the bottom tray "dirty" and not allowing grease to fl ow
into catch pan?
Are burners clean?
The lid is porcelain enamel or stainless steel, not paint. It
cannot "peel". What you are seeing is baked on grease
that has turned to carbon and is fl aking off.
THIS IS NOT A DEFECT.
Check the adjustment pin on the bottom of each door.
SIDEBURNER TROUBLESHOOTING
CHECK
Is gas supply off?
Is the fuel hose bent or kinked?
Does burner light with a match?
CHECK
Clean Spider / Insect Screens. (See Section "Annual
Maintenance")
Straighten fuel hose.
If you can light the Left burner with a match, then check the
electronic ignition system.
All burners on "HI" for 10 to 15 minutes for preheating.
®
bars heavily
Clean thoroughly. (See Section "Cleaning")
Clean bottom tray
Clean burners. (See Section "Maintenance".)
Clean thoroughly. (See Section "Cleaning".)
Loosen adjustment nut/s. Slide door/s until aligned. Tighten
nut.
Turn supply on.
Straighten hose.
If match lights burner, check igniter (see below).
15
CURE
CURE
15
Publicidad
