Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND CLEANING
CAUTION: Always use the handle to lift the pump. Never use the power cord to lift the pump. To avoid skin burns,
unplug the pump and allow time for it to cool after periods of extended use.
If the pump flow drops off, the most likely cause is something solid going down the drain and jamming the impeller.
To clear a jammed impeller:
Unplug the pump.
Close the discharge ball valve (C).
Bail out the sink as much as possible.
Disconnect the union (Part No.5), unscrew the pump
from the sink tail piece, lower the pump to the floor, and
slide it out from under the sink (see Figure 3).
Remove the six housing screws (see Figure 4).
Clean out the pump. Make sure that the pump discharge
is clear. If necessary, replace the impeller.
Install the new gasket if necessary. Reassemble the
pump.
Raise the pump back into position, thread it back onto
the sink tail piece, and reconnect the union (Part No.5).
Plug in the pump. Run water in the sink until the pump
has run at least one complete cycle to make sure the
pump is operating correctly and there are no leaks.
Repair Part List
For Technical Support call 1-844-242-2475
Figure 4: Remove 6 housing screws to clean out
pump
No.
Part Description
1
Diaphragm Switch
2
Impeller
3
Gasket
A
Sink Drain Screen
B
1-1/4" NPT x 1-1/4" Slip Check
Valve
C
1-1/4" NPT Ball Valve
Qty.
1
1
1
1
1
1
7
Publicidad
