Publicidad
Idiomas disponibles
Idiomas disponibles
Parts are located throughout the shipping carton, including underneath the griddle. Inspect the unit and parts after removing
from the protective shipping carton. Discard all packaging materials from inside and outside of the griddle before assembly, then
review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt to assemble. Shipping
damage is not covered under warranty. Contact your dealer or Pit Boss® Grills Customer Care for parts.
Tools required for assembly: screwdriver. Tool not included.
-
It is advised to review each step entirely before starting assembly on instructions.
1
Hand tighten the firebox feet.
2
Review the "Connecting to a Gas Supply" section.
1
Use a screwdriver to remove pre-installed screws.
GAS CYLINDER REQUIREMENTS
The griddle is set and tested with liquid propane gas only. When purchasing a gas cylinder for use with this unit, ensure it meets
the following requirements: 0.45 kg (1 lb) / 19.6 cm (7.75 in) capacity, marked "PROPANE", constructed and marked in accordance
with Specifications for LP Gas Cylinders of the U.S. Department of Transportation (DOT) or the National Standard of Canada,
CAN\CSA-B339, Cylinders, Spheres and Tubes for Transportation of Dangerous Goods; and Commission, as applicable (see label for
marking). This griddle has been provided with a cylinder connection device that is compatible with the griddle's regulator port.
CAUTION: It is important to inspect the cylinder connection device. Check the propane tank valve
rubber seal for cracks, wear, or deterioration prior to use. Do not use a propane tank with a damaged
rubber seal.
A minimum clearance of 610 mm (24 inches) from combustible constructions to th side of the grill, and 610 mm (24 inches) from
the back of the grill to combustible constructions must be maintained.
WARNING: Failure to inspect this connection or follow these instructions could cause a fire or an
explosion, which can cause death or severe bodily harm.
ASSEMBLY PREPERATION
USA: 480-923-9630 | CANADA (TOLL FREE): 1-877-942-2246
GO TO PAGE 54 FOR STEP-BY-STEP ASSEMBLY DIRECTIONS.
IMPORTANT
NOTE
CONNECTING TO A GAS SUPPLY
7
Publicidad
