Publicidad
Idiomas disponibles
Idiomas disponibles
ae
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
Note to CATV system installer:
This reminder is provided to call the CATV
system installer's attention to Article 820-
40 of the NEC that provides guidelines for
proper grounding and, in particular,
specifies that the cable ground shall be
connected to the grounding system of the
building, a close to the point of cable entry
as practical.
DE
st
Features
¢ The TGV-100 TV tuner unit is for Sony
VCRs such as GV-A500.
¢ The power to the tuner unit is supplied
from the VCR.
¢ The tuner unit is turned on or off
simultaneously with the VCR.
¢ You can enjoy watching and recording TV
programs by VCR using this unit. (The
sound is monaural.)
aaa
eg)
ne
ee)
Precautions
Operation
¢ Do not carry the VCR by the tuner unit.
* Keep the terminal clean. Avoid touching
the terminal.
¢ Prevent metal objeets such as a key holder
from touching the terminal.
* Hold the tuner unit while adjusting the
antenna.
:
¢ Should any solid object or liquid fall into
the cabinet, especially into the terminal,
have it checked by qualified personnel
before operating it any further.
¢ Avoid rough handling or mechanical shock
to the unit.
¢ Do not wrap up the unit and operate it
because heat may build up internally.
* Avoid using and storing the unit in
locations:
- susceptible to vibration
- exposed to strong magnetic fields
- near TV or radio transmitters where
strong radio waves are generated
- on the sand
Power sources"
--
If the battery becomes low, the unit may not
operate. Use the AC power adaptor for an
important occasion.
Care
Clean the unit body with a dry, soft cloth, or
a soft cloth lightly moistened with a mild
detergent solution. Do not use any type of
solvent, as this may damage the finish.
4 Press AUTO PRESET.
The unit starts to search for receivable
channels. After about two minutes,
the preset channels will appear on
the LCD screen and the lowest-
numbered channel is tuned in.
Once you preset the channels, you do
not need to repeat this procedure
each time you use this tuner unit.
> Operating the unit
Watching TV
programs
(See Fig.{@)
1 Set INPUT SELECT to TUNER.
2 Set the POWER switch on the
VCR to ON.
The power lamp on the tuner unit
lights up.
3 Press CHANNEL +/- to select the
channel.
If you cannot find a channel you
want to watch, see "Scanning
channels".
4 Adjust the telescopic antenna for the
best reception.
If you have connected an external
antenna, skip this step.
5 Adjust volume and brightness on the
VCR.
To improve the picture
If the picture is not clear, set BOOSTER on
the rear to OFF. Normally set it to ON.
To display the channel
Press DISPLAY. It is displayed for about 3
seconds.
Note on channel display
The actual channel numbers of TV stations may
differ from the channel numbers displayed on the
LCD.
"Last channel" memory function
The unit always turns on to the channel you
previously selected.
.
After using the unit
1 Turn off the VCR.
2 Replace the antenna in the order of @, @,
®.
Publicidad
