Publicidad
Idiomas disponibles
Idiomas disponibles
• To move the motor housing up, turn the micro depth
adjustment knob toward the "up" arrow to the side of
the knob.
„ The cutter depth can be read on the depth scale on
the motor housing. Each mark on the scale indicates a
1/16 in. change in depth setting. Use the top edge of the
removable base as reference when setting depth of cut.
„ Push the quick release lever to the closed position.
WARNING:
Avoid open area of router base. Serious personal injury
will result from contact with a rotating bit.
NOTE: To make deeper cuts, it is necessary to make as
many successive passes as required, lowering the bit
1/8 in. for each new pass. To save time, perform all the cut-
ting necessary at one depth setting, then lower the bit for
the next pass. This will assure uniform depth when the final
pass is completed.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
NOTE: ILLUSTRATIONS START ON PAGE 12 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION
USING EDGE GUIDE
See Figures 15 - 16, page 14.
Use the edge guide to trim or cut a straight or curved edge.
„ Remove the battery pack.
„ Thread guide bars into the base and tighten with a flat
head screwdriver.
„ Slide the edge guide onto the guide bars.
„ Install thumb screws into the edge guide.
„ Measure the proper distance to offset the bit, or if
trimming, position the bit at the edge of the workpiece.
„ Tighten the two thumb screws to secure the edge guide.
„ Reinstall the battery pack.
„ Move the router along the workpiece keeping the edge
guide in constant contact with edge of the workpiece.
MAINTENANCE
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
10 — English
Publicidad
