Publicidad
Idiomas disponibles
Idiomas disponibles
2. MOUNTING THE LEGS TO THE MAIN BARREL
Parts Required:
1
x
Main Barrel (#12)
1
x
Support Leg for Wheel / Front (#15)
1
x
Support Leg for Wheel / Back (#16)
1
x
Bottom Shelf (#23)
8
x
Screw (#A)
8
x
Washer (#B)
8
x
Locking Washer (#C)
Installation:
•
Place a piece of cardboard on the floor to prevent scratching the unit and
parts during assembly. Lay the Main Barrel on its side on the cardboard,
hopper end pointed upward.
•
Mount a Support Leg with Wheel to the floor end of the Main Barrel
using three screws, locking washers, and washers, through the three
pre-drilled holes. Install screws from the inside of the Main Barrel.
Repeat installation for second Support Leg with Wheel. Note 2A.
•
Mount the Bottom Shelf to each Support Leg using a screw, locking
washer, and washer. Ensure the flat surface of the shelf is facing up
towards the Grill Barrel. Note 2B.
3. SECURING THE FRONT PANEL
Parts Required:
1
x
Front Panel (#21)
2
x
Screw (#D)
1
x
Screw (#H)
Installation:
•
Secure the Front Panel to the front Support Leg of the unit using two
screws (#D). Ensure the flat side of the Support Plate is facing outwards.
Note 3A.
•
Next, open the lid of the Main Barrel. Install one screw (#H), from the
inside of the Main Barrel, into the Front Panel. Note 3B.
8
2A
12
16
15
2B
23
B
C
A
3A
21
D D
3B
21
H
A
C
B
Publicidad
