Publicidad
Idiomas disponibles
Idiomas disponibles
Slide Switch
• Normal: default mode; allows normal communication between all ports.
• Flow Control: disables the switch's flow-control function.
• VLAN: isolates ports (561273: 1 – 22; 561815: 1-14) from each other
• Extend: allows ports 1 – 8 to achieve transmission distances
Rear Panel
Power
Use the included power cord to connect the device (on the rear panel) to
an AC outlet. The device supports AC 100 – 240 V, 50/60 Hz.
Chassis Ground Column
Located on the side of the power supply connector, a grounding terminal connector is used to
provide proper grounding for your Intellinet Network Solutions switch. If you use the chassis
grounding screw, it should be wired to an object that provides earth ground. In rackmount
installations, grounding is typically provided by the metal frame of the mounting rack.
Placement
Desktop Installation
Prior to use, it is recommended that the switch be placed/positioned on a level surface that
can support the weight of the switch (and possibly other objects) with at least 25 mm (approx.
1") of clearance for ventilation; away from sources of electrical noise: radios, transmitters,
broadband amplifiers within 100 m (approx. 328') of network devices it's to be connected to.
Attach the rubber feet to the bottom of each corner of the switch to increase stability.
Rackmount Installation
The switch can be mounted in an EIA standard-
sized, 19-inch rack. Attach the mounting brackets
on the switch's side panels (one on each side)
and secure them with the screws provided.
Use the screws provided with the equipment
rack to mount the Intellinet Network
Solutions data switch on the rack.
while allowing them to connect to ports (561273: 23-24; 561815: 15-
16); increases the forwarding rate when broadcast storms occur.
up to 250 m (820 ft.) at a reduced speed of 10 Mbps.
Instructions
3
English
Publicidad
