MESTIC 1512700 Instrucciones De Uso página 11

17. Keep enough distance between product and objects and walls.
18. Never immerse the device in water
19. Ventilation slots are not covered at all times.
20. When the appliance is moved, installed or used, special attention must be paid to the cooling system so that it is
not damaged.
21. When positioning the device, ensure the supply cord is not trapped or damaged.
22. The compressor can operate up to an angle of 30°, while greater angles can cause permanent damage to the
compressor.
General instructions for proper use
1. Opening the refrigerator door more often than necessary increases energy consumption and frost.
2. Proper ventilation of the compressor and condenser unit reduces energy consumption and ensures a good cooling
performance.
3. Keep the inside of the refrigerator clean and dry. Remove any condensate water which might gather in the tray
under the freezer compartment.
4. It is recommended to turn on the device for about 6 hours prior to storing any food.
5. Make sure the wiring system of the vehicle is in proper condition. Routinely check the batteries and the charge
level.
Warning! Electrical shock hazard!
1. Do not remove the ground prong.
2. Do not use an adapter.
3. Do not use an extension cord.
First use
1. Check whether all packing materials have been removed.
2. Clean the inside of the refrigerator with warm water and a mild detergent.
3. Gently dry with a soft cloth.
4. The refrigerator should always be plugged into its own individual electrical outlet which has a voltage rating that
matches its rating plate. The refrigerator can be operated with a 12 V or a 24 V DC voltage supply.
Battery power detection
The device features a multi-level battery guard that protects your vehicle battery from excessive discharge when the
device is connected to the built-in DC power supply. If the cooler is operated with the vehicle ignition off, the cooler
will shut off automatically when the power supply voltage drops below a set level. The cooler will turn back on once
the battery is charged to the restart voltage level. The compressor will restart automatically in a few minutes when the
voltage returns to normal values.
Cut-off voltage
Cut-in voltage 10.9 V
12V 24V
9.6 V 21.3 V
22.7 V