Publicidad
Idiomas disponibles
Idiomas disponibles
FlashLight
Holder install manual when wire outside the wall
Figure 15
1) Open the packaging and take
out the accessories for installation.
Figure 16
4) Pass the wire through the circle,
x the holder on the wall by Ø 3.8 *
30mm self-tapping screw.
85265
2) As shown in the picture, drill two
holes with 6mm diameter and
35mm depth according to the
spacing between the two xed
holes on the bracket which is
55mm, put the nails in these.
5) Take out the decorative ring as
the direction showed.
Figure 12
3) Poke through the semicircular
thin wall at the corresponding side
of the wire with sharp.
Figure 17
6) Remove the yellow cover as the
direction showed.
Opening your life
Figure 17
Figure 18
1 4
Publicidad
