Sony HT-XT1 Manual De Instrucciones página 11

_PUl \
lu rUNG /
VOL
OUNO
IELD
OICE /
/ J%
_lem
REYU_N
MENU
I' 4, (select)
ENTER
RETURN
Menu Function Default
HDMI ON
CTRL
(Control for HDMI)
P. THRU
(Pass through)
To switch the Control for HDMI function on or off. ON/OFF
Refer to "Using the Control for HDMI function" page 6 for details.
To set the power saving mode of the pass-through function for
HDMI signals. (AUTO/ON)
AUTO: Outputs signals from the HDMI OUT jack of the system in
standby mode according to the status of the TV. This setting
saves power in standby mode compared with the "ON"
setting.
ON: Always outputs signals from the HDMI OUT jack in standby
mode. If any TV other than "BRAVlA" is connected, use the
system with the "ON" setting.
Note: This item appears only when "CTRL (Control for HDMI)" is set
to "ON."
AUTO
ARC To listen to digital sound from a TV compatible with the Audio
(Audio return channel) Return Channel ARC technology that is connected using a High
Speed HDMI cable. ON/OFF ON
Note: This item appears only when "CTRL (Control for HDMI)" is set
to "ON."
SET BT BT PWR To switch the BLUETOOTH function of this system on and off. (ON/
(BLUETOOTH power) OFF) ON
Note: If you change the setting to "OFF," the BLUETOOTH function
and the NFC function become disabled•
BT.STBY When the system has pairing information, the system is in the
(BLUETOOTH standby) BLUETOOTH standby mode even when it is turned off. (ON/OFF) ON
AAC To set whether or not the system will use AAC via BLUETOOTH.
(Advanced audio (ON/OFF)
coding) Note: If you change the setting when the system is connected with ON
a BLUETOOTH device, the system will be disconnected from
the device•
SYSTEM A. STBY To switch the AUTO POWER OFF function on or off. (ON/OFF)
(Auto standby) The system turns off automatically when no operation has been ON
made within a certain period (about 20 minutes) and the system is
not receiving an input signal.
VER To display the current firmware version.
(Version)
SYS.RST To reset menus and settings (sound fields, etc.) of the system to
(System cold reset) the initial status when it does not work properly.
Refer to "Troubleshooting" (page 18) for details.
11us